Wireless Control is as Easy as Talking to a USB Port on Your Computer!
All The Features You Need...
Mounts as a Virtual COM Port
Plug In, Open the COM Port and Start Sending Commands
Programmable Baud Rate
Not Compatible with all devices, Select the Modem for Your Wireless Protocol You are Using
LED Status Lights Indicate Communication
USB Powered
Includes USB Cable
Includes Enclosure
Wireless Modem 802.15.4, XSC and ZB ZigBee
Communicating with a Wireless Device does NOT have to be complicated. Our line of wireless modems allow first time users to communicate with the wireless protocol installed oh your board.
USB Computer Connection
Plug the wireless Modem into a USB port on your computer and install the drivers. The modem will mount as a COM port on your PC. Next, talk to the COM port as though you were communicating with a RS-232 serial device that is directly connected to your PC. That's all there is to it!!!
2-Way Communications
All wireless Modems offer wireless 2-way communications, compatible with any boards on this site with the same wireless protocol. These devices are Powered by the USB Port. The modems includes USB Cable and Enclosure.
Modems with part number ending in ZIGMO will feature our new case for modems with an external antenna and is wall mountable, smaller and features status lights so you'll know you're connected.
Wireless Control is as Easy as Talking to a USB Port on Your Computer!
Displaying 1 - 4 of 4 Products in this Category.
Display Page: ( 1 )
ZBU_COORD_ZIGMO
ZB ZigBee Mesh Coordinator (used to talk to a ZB Mesh network)
The ProXR Series Controller allow computers to read contact closure inputs, analog to digital converters and control up to 256 Relays using a single computer interface. ProXR series controllers focus on expansion for industrial control applications.
The ProXR Lite product line allows computers to read up to 8 analog inputs and control up to 8 relays.
Non-Expandable, the ProXR Lite Product Line focuses on interchangeable Computer Interface Modules and Low Cost
Focusing on Cost Reduction and High Volume Manufacturing, the Low Cost Series are No-Frills Relay Controllers that offer Basic Computer Control at Low Communications Speed.
Activate Relays when Sensors Reach Limits. Trigger Timers, Counters, and Events.
Use a Computer to Setup the Reactor, then Let the Reactor Work by itself without a computer.
Manually Take Control of Relays from Anywhere in the World using a Computer as needed.
Activate Relays with a Remote Control Key Fob. Trigger Timers, Counters, and Events.
Use a Computer to Setup the Key Fob Reactor, then Let the Key Fob Reactor Work by itself without a computer.
Manually Take Control of Relays from Anywhere in the World using a Computer as needed.
Time Schedule Activated Relays with Computer Interface. Use a Computer to Setup the Time Schedule.
Taralist Series Controllers do not require a computer after initial configuration.
Manually Take Control of Relays from Anywhere in the World using a Computer as needed.
The MirC Product Line Consist of TWO Controllers, Offering Contact Closure Inputs in One Location that Control Relays in a Remote Location.
The Transmitter Shows the Status of the Receiver. Smart Features optionally Turn Off Remote Relay if Communications is Lost. Sold in Pairs ONLY.
The MirX Product Line Consist of TWO Controllers, Offering Contact Closures and Relays on Each Controller. The Contact Closure Inputs at Location A control Relays at Location B. The Contact Closure Inputs at Location B control Relays at Location A. Each Controller Remotely Controls the Other. Smart Features optionally Turn Off Relays if Communications is Lost between the Two Controllers. Sold in Pairs ONLY.
Contact Closure to Multiple locations. MirM controllers allow contact closure inputs to control relays in remote locations using multiple relay boards. The sender board is equipped with contact closure inputs, used to control relays on the receiver boards. Both sender and up to 24 remote receiver boards are included when you purchase the MirM Series boards.